It is currently Thu Mar 28, 2024 7:23 pm

All times are UTC [ DST ]




Post new topic Reply to topic  [ 2 posts ] 
Author Message
PostPosted: Sat Feb 14, 2015 10:28 pm 
Offline

Joined: Tue Dec 25, 2012 12:34 am
Posts: 31
Hi,
I'm converting my Mk1 Fiesta to Zetec and have the 1.8 gti all in and mounted.
I bought a cult ECU and engine loom and found apart from the large 12 pin oval plug nothing else plugs in.
I also have a Escort Si complete loom and ecu. Most of the plugs fit with the exception of the two pin plug to the sensor in the top of the stat.I have the key and transponder ring with the small green block on the loom plugged into the transponder ring.
Can anyone advise me on how to wire it into the loom.
I cant seem to make head nor tail of what I wire where so need a bit of an idiots guide!
Any help would be much appreciated


Top
 Profile  
 
PostPosted: Sun Feb 15, 2015 1:41 am 
Offline

Joined: Fri May 23, 2003 11:04 pm
Posts: 22291
Location: County Durham.
I know there are two versions of the temperature sensor that fit into the top of the thermostat.
Earlier one's are round and look like the later Mk2 Fiesta and Mk4 Escort plugs.
The later one's are square and are from the later Mk5 Escort and onwards cars.
Just change the sensor for the one you need.

As for wiring it all up...
Pretty sure there's a couple of guides on here.
Have you checked the FAQ?

Jason.


Top
 Profile  
 
Display posts from previous:  Sort by  
Post new topic Reply to topic  [ 2 posts ] 

All times are UTC [ DST ]


Who is online

Users browsing this forum: No registered users and 19 guests


You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum

Search for:
Jump to:  


Powered by phpBB® Forum Software © phpBB Group